		Class Description

CLASS NUMBER:

3211-37

DESCRIPTION:

INDUSTRIAL CONTROL SUB-ASSEMBLIES-Components

COVERAGE:

Components and sub-assemblies of industrial control equipment which have no inherent independent use, but which form a part of a complete product, and for which construction and/or test requirements exist in CSA Industrial Control Equipment (and related) Standards.

Examples of components and sub-assemblies for which this programme is intended include the following: gasket materials intended for use in special purpose enclosures, enclosure - frame, cover, door, fastener, interlock components etc; pre-designed bus assemblies:

REQUIREMENTS:

CSA Standard C22.2 No 0	General Requirements - Canadian Electrical Code, Part II
CSA Standard 0.4	Grounding and Bonding
CSA Standard 14	Industrial Control Equipment
CSA Standard 94	Special Purpose Enclosures

Note: These components and sub-assemblies are investigated for use only as components of electrical and electronic equipment where the acceptability of the final assembly is to be determined. Other notes applicable to specific products or submittors are detailed in the individual submittor's listing.

MARKING:

All marking required by CSA must be permanent, legible and located on the component/sub-assembly or the smallest packaging and will include:

submittor's identification (Company Name, CSA Registered Trademark or CSA file number;
model designation or part number or equivalent;
additional markings as may be required by the applicable Standards and Notices; and
CSA Component Acceptance Mark with the Component Acceptance (Triangle) Indicator.

mkc